To be assembled on short and long frame Santana Sj and Suzuki Samurai, EXCEPT narrow 410. To be assembled between the front axle and the transfer case. Compressed length: 68,5cm. Screws interaxial: 5,6cm . Quality: original
To be assembled between the rear axle and the transfer case. Cross handle axle to axle compressed length : 410mm. Fastening interaxial : 56mm. Quality: original
Dimensions: 23.72mm x 61.60 mmSuitable for Suzuki Santana Samurai 4WD.Including retaining rings and a grease nipple.Standard quality.
Dimensions: 23.72mm x 61.60mmSuitable for Suzuki, Santana, Samurai and Jimny 4WD.Circlips included.reinforced quality.
Dimensions: 25mm x 64mm.Suitable for Suzuki Santana Samurai 4WD.Circlips and a grease nipple included.Standard quality.
Dimensions: 25mm x 64mm. Suitable for Suzuki Santana Samurai 4WD.Circlips included.Enhanced quality.
Manual grease pump.Its small size enables to have an easy access to u-joint grease nipple.Delivered without grease.
To be assembled on front or rear driveshafts. Quality: original
To be assembled on front or rear driveshafts.
To be assembled between the gearbox and the transfer case. Axle to u-joint axle length : 249mm. Fixing interaxial : 55mm. Quality: original
Mouting flange for cross piece (25mm x 64mm).To be assembled on Suzuki santana 410, 413, samurai, essence, diesel and turbo diesel.
To be assembled on long framed Samurai (wide drive axle). To be assembled between the rear drive axle and the transfer case. Cross handle axle to axle compressed length : 755mm. Fastening interaxial : 56mm.Quality: original
Diameter : 6 mmThread : 100Sold individually.
Transmission sliding yoke, gear box side, for 25mm x 64mm U-joint.To be assembled on petrol / diesel / turbo diesel Suzuki Santana 410, 413 4WD.
Purchase a gift voucher