Ultra-manual declutching.Suitable for all Suzuki and Santana 410, 413, samurai, petrol, diesel and turbo-diesel. Sold in pairs.
Standard quality rear wheel roller bearing kit for all suzuki and santana, 410, 413, gas and diesel 4WD. To be assembled on the rear, right or left. Delivered with race and seal.
This screw is used for the reassembly of wiper seal plates on diesel and turbo diesel Suzuki Santana Samurai 410 and 413.Sold individually (16 pieces necessary per vehicle).
Suitable for all Suzuki Santana 410, 413, petrol, diesel and turbo diesel.These Suzuki Samurai Knuckle rebuild kits are for front right and front left sides.The kit is composed of:- 4 front wheel bearings- 4 pivot bearings- 2 wiper seal and clamp ring kits- 2 half-shaft seals
Original quality rear wheel enhanced roller bearing kit for Suzuki and Santana 410, 413, gas and diesel.To be assembled on the rear right or left.Rings and seals included.
Complete kit for front right and left :- 4 pivot roller bearings.- 2 wiper seal kits.- binding rings.- 2 enhanced quality halfshaft seals.
To be assembled on the rear right or left. Dimensions: 62mm x 48mm x 9mm
Complete original quality kit for one side (front right or front left) :- 2 pivots' roller bearings.- 1 big wiper seal.- 4 half-moons.- 1 felt ring.- 1 halfshaft sealing.
Rear wheel roller bearing protection ring.Sold individually.
Rear axle bump stops.To be assembled on all santana sj410, sj413 and samurai, gas or diesel.Sold in pair.
This wiper seal kit for Suzuki and Santana 410, 413, samurai, petrol and diesel includes these adaptable elements :- 4 felt fastening half-moons.- 2 parts felt.- 1 O-ring seal.Right or left side build.
This wiper seal kit for Suzuki and Santana 410, 413, samurai, petrol and diesel contains original elements :- 4 thin felt fastening keepers.- 2 parts thin felt.- 1 O ring
Not suitable for narrow axle 410. To be assembled at the entrance of the differential carrier to render it hermetic.Dimensions : 72mm x 40mm x 11mm.
To be assembled on the front, right or left. Delivered with its seal.
Exterior roller bearing for the differential carrier’s drive pinion.To be assembled in the front or rear differential carrier.Original quality.
Interior drive axle nose pinion roller bearing. To be assembled in the front or rear drive axle nose. Quality: original
To be assembled on the front left or right. Dimensions: 26mm x 38mm x 7mm
To be assembled in between the two drive pinion roller bearings, in the front or rear drive axle nose.Original quality.
Interior roller bearing for the differential carrier’s drive pinion.To be assembled in the front or rear differential carrier.Original quality.
Front axle bump stop.Sold by pair.To be assembled on all Santana, sj410, sj413 and samurai gas or diesel.
Front polyurethane axle bump stop.Sold in pairs.
To be assembled on all Suzuki Santana Samurai gas and fiesel 4WD, EXCEPT narrow axle 410. For mounting with M8 screws. Quality: original
Complete cardan, including the axle shaft and the constant-velocity joint.To be assembled on models with a wide tread on the right side.Length : 54cm.Original parts manufacturer
Conical plug. Diameter : 20.5 mm Threading : 1.75
Purchase a gift voucher